They Look Similar on a Spec Sheet
Both steel (ISO P) and stainless steel (ISO M) are ferrous materials. Machinists regularly assume that a good steel insert will handle stainless with a 20% speed reduction. This assumption causes more tool failures and poor surface finishes than almost any other single mistake on the shop floor.
Why Stainless Is Fundamentally Different
Stainless steel — 304, 316, 17-4PH, duplex — work-hardens the moment the cutting edge contacts it. Every time you rub instead of cut, you are making the next cut harder. The austenitic structure is also extremely sticky — it has high affinity for the cobalt binder in carbide, which is the mechanism behind built-up edge (BUE).
ISO M grade inserts address both problems. The substrate is tougher to handle higher thermal gradient. TiSiN coating in TFX-M35 has lower chemical affinity for austenitic steel, directly suppressing BUE. The chipbreaker geometry is sharper and more positive, reducing cutting force that would cause work-hardening ahead of the tool.
The Three Rules for Stainless
Rule 1: Never dwell. If the spindle stops with the insert in contact with the workpiece, the contact zone work-hardens immediately. Retract first, always.
Rule 2: Minimum DOC of 0.15mm. Below 0.15mm the edge is rubbing on the work-hardened layer from the previous pass. In finishing, if you need a fine cut, take it in one light pass — not multiple very-light passes.
Rule 3: Continuous feed only. Feed override reductions are common habits from steel machining — on stainless they cause the exact rubbing problem that destroys edges.
Grade Selection Summary
304/316 austenitic: TFX-M35 (TiSiN) at Vc 70–100 m/min (turning), 50–70 m/min (milling). Duplex/super-duplex: reduce Vc by 20–25%, through-coolant mandatory. 17-4PH in aged condition: behaves more like P-grade steel — TFX-P25 works, check hardness first. Above 36 HRC, consider TFX-H15 for finishing.